Notifications
Clear all
Topic starter
Refer to the exhibit.
After configuring IS-IS on routers R1 and R2, an engineer notices that only the loopback interface at 2000:1::1 /96 is known to router R2 .
Which change must be made so that only Loopback2 is advertised from R1 to R2?
- A . Configure the router isis areal command under the LoopbackO interface on R1.
B. Remove the advertise passive-only command under the IS-IS address family ipv6 configuration
C. Remove the ipv6 router isis areal command under the Loopback2 interface on R1.
D. Remove the passive-interface Loopback0 command under the router isis areal configuration.
Suggested Answer: B
Posted : 19/12/2022 5:51 am