Forums
Dumps Discussion
Cisco
300-510
 
Notifications
Clear all

300-510

Share and discuss the opinions about the dumps with all 300-510 Q&As.
RSS
Page 1 / 3
Topic Title
Views
Posts
Participants
Which of these can the operator use the routing policy language for, to enforce this traffic forwarding path?
Chuck, 1 year ago
124
1
No replies
In a PIM-SM environment, which mechanism determines the traffic that a receiver receives?
Randolph, 1 year ago
98
1
No replies
Which step should the engineer take before the segment routing is enabled and is running with BGP?
Carrol, 1 year ago
104
1
No replies
Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Software?
Vicente, 1 year ago
117
1
No replies
Which action resolves the issue?
Philip, 1 year ago
130
1
No replies
The extension header of the IPv6 header is ignored when which value is equal to zero?
Philip, 1 year ago
110
1
No replies
Which attribute can router 1 alter so that only other iBGP peers prefer to use 192.168.4.2 as the next hop for route 192.168.3.0/24?
Esteban, 1 year ago
77
1
No replies
For that purpose, the following AS Pam prefix 1st s being used:
Zachariah, 1 year ago
76
1
No replies
Which type of BGP attribute does a route reflector attach to routes learned from iBGP peers that allows them to be accepted by other iBGP peers, thereby eliminating the need for a full-mesh BGP topology?
Wilber, 1 year ago
88
1
No replies
Which configuration should the engineer apply on R1 to summarize routes?
Arden, 1 year ago
145
1
No replies
Which configuration resolves the issue?
Vicente, 1 year ago
84
1
No replies
Which factor might explain this issue?
Orval, 1 year ago
79
1
No replies
Which action must be taken to correct the problem?
Galen, 1 year ago
78
1
No replies
What are three requirements for a static IPv6-in-IPv4 tunnel? (Choose three.)
Eldridge, 1 year ago
96
1
No replies
Which difference must an engineer consider when choosing whether to implement OSPF or IS-IS as the routing protocol on the network?
Man, 1 year ago
88
1
No replies
Which statement about this configuration is true?
Marshall, 1 year ago
80
1
No replies
Which configuration meets this need?
Dante, 1 year ago
87
1
No replies
Which output from the show isis interface command helps an engineer troubleshoot an IS-IS adjacency problem on a Cisco IOS-XR platform?
Coy, 1 year ago
76
1
No replies
What is the effect of it?
Isreal, 1 year ago
87
1
No replies
Which action resolves the issue?
Carrol, 1 year ago
79
1
No replies
Why is neighbor 10.1.5.5 stuck in “2WAY” state?
Lewis, 1 year ago
227
1
No replies
How should the engineer solve the issue?
Harris, 1 year ago
70
1
No replies
What is the difference between a source tree and a shared tree in a multicast environment?
Lewis, 1 year ago
134
1
No replies
What can be used to determine a path from the head-end to a tail-end router when implementing SR-TE with a head-end, with little information on the network topology?
Randolph, 1 year ago
95
1
No replies
What should the engineer do to fix the problem so that BGP allows that prefix on R2?
Ezequiel, 1 year ago
91
1
No replies
Which policy configuration applied to the XR3 neighbor configuration for XR1 can accomplish this requirement without impact to other or future received routes?
Dante, 1 year ago
87
1
No replies
Drag and drop the features about multicast from the left onto the multicast protocols on the right. Not all options ate used
Giovanni, 1 year ago
94
1
No replies
Which action resolves the issue?
Gonzalo, 1 year ago
97
1
No replies
What are two differences between OSPF and IS-IS? (Choose two.)
Vicente, 1 year ago
83
1
No replies
The engineer verified that:
Guillermo, 1 year ago
85
1
No replies
Page 1 / 3
Share: