In this scenario, what should you do next?

After you install an AFF A700 2-node cluster with DS224C shelves, Config Advisor reports that your SAS cabling is in mixed-path HA. You expected the SAS cabling be in quad-path HA.

You physically verify the LED status on the controllers and the shelves and notice no irregularities. However, a reboot of the SAS expander does not change the output.

In this scenario, what should you do next?

A. Open a case with NetApp Support and turn off the disk shelves until the issue is solved.

B. Disconnect the disk shelves from the controller and run Config Advisor again.

C. Re-seat the SAS IO modules of the affected AFF A700 controller.

D. Use multipath HA because it is the only cabling supported on an AFF A700 controller.

Show Answer Hide Answer