Notifications
Clear all
Topic starter
Exhibit:
You are working on a disaster recovery situation where the controller, which is part of a fabric-attached MetroCluster configuration in the disaster site, fails to boot and stays at the loader prompt. This failure generates the error message that is shown in the exhibit.
Which sequence of steps will recover the disaster site?
- A . Perform switchback, heal data aggregate, heal root aggregate, and boot ONTAP.
B. Heal root aggregate, heal data aggregate, boot ONTAP, and perform switchback.
C. Heal data aggregate, heal root aggregate, boot ONTAP, and perform switchback.
D. Boot ONTAP, heal root aggregate, heal data aggregate, and perform switchback.
Suggested Answer: C
Posted : 03/12/2022 3:52 pm