Notifications
Clear all
Topic starter
An administrator is defining a VSX LAG on a pair of AOS-CX switches that are defined as primary and
secondary. The VSX LAG fails to establish successfully with a remote switch; however, after verification, the remote switch is configured correctly. The administrator narrows down the problem to the configuration on the AOS-CX switches.
What would cause this problem?
- A . Local optimization was not enabled on the VSX LAG
B. The VSX LAG hash does not match the remote peer
C. The VSX LAG interfaces are in layer-3 mode
D. LACP was enabled in active mode on the VSX LAG
Suggested Answer: B
Posted : 05/11/2022 6:21 am