Forums
Dumps Discussion
Huawei
H12-831_V1.0
 
Notifications
Clear all

H12-831_V1.0

Share and discuss the opinions about the dumps with all H12-831_V1.0 Q&As.
RSS
Page 3 / 9
Topic Title
Views
Posts
Participants
The DHCP protocol can assign some TCP/IP-related parameter information to the client. In this process, DHCP defines a variety of messages. The encapsulation of these messages is?
Harris, 1 year ago
61
1
No replies
What is the core idea of ​​network troubleshooting?
Gonzalo, 1 year ago
122
1
No replies
All neighbor relationships have been established. How many routing entries exist in the BGP routing table of Client2?
Guillermo, 1 year ago
75
1
No replies
As shown in the figure, on the R1 router, network administrator A can control the path of the traffic leaving AS100 after modifying the Local Preference value of the routing entry sent to R2 through the routing policy.
Eldridge, 1 year ago
68
1
No replies
When MPLS is deployed in the network and the network layer protocol is IP, the route corresponding to the FEC must exist in the IP routing table of the LSR, otherwise the label forwarding entry of the FEC will not take effect.
Morgan, 1 year ago
67
1
No replies
For the same MAC address, manually configured MAC entries have higher priority than automatically generated entries.
Randolph, 1 year ago
68
1
No replies
As shown in the figure, OSPF is enabled on all interfaces of the router, where R4 and R5 can establish OSPF virtual connections.
Rueben, 1 year ago
62
1
No replies
Part of the configuration of R1 is as follows. Which statement about OSPF on R1 is correct?
Colton, 1 year ago
97
1
No replies
After a fault occurs, it is necessary to collect and backup various types of fault information in time as a reference for handling faults.
Carmelo, 1 year ago
95
1
No replies
By default, LDP adjacencies will trigger the establishment of LSP based on IP routing of 32-bit addresses.
Rolando, 1 year ago
81
1
No replies
In the firewall interzone security policy, which of the following data flow is not in the outbound direction?
Guillermo, 1 year ago
81
1
No replies
As shown in the figure, the APLS LSP is configured in the network and the goal is to establish an LDP session between SWA and SWB, then which of the following statement is correct?
Rashad, 1 year ago
71
1
No replies
Which of the following is not a service provided by MACsec?
Isreal, 1 year ago
95
1
No replies
When configuring MPLS VPNI, the administrator configured the command: interface GigabitEthernet0/0/0 ip binding vpn-instance VPN1 Interface GigabitEthernet0/0/1 ip binding vpn-instance VPN2. Which of the following description is wrong?
Esteban, 1 year ago
74
1
No replies
QinQ technology is a technology to expand the VLAN space. It can achieve the function of expanding the VLAN space by adding a layer of 802.1Q Tag on the basis of the 802.1Q tag message. Which of the following statements about QinQ is false?
Man, 1 year ago
69
1
No replies
BFD can implement link state detection at the s (millisecond) level.
Tuan, 1 year ago
90
1
No replies
Configured on an interface: isis timer hello5 level-2, which of the following statements is correct?
Giovanni, 1 year ago
89
1
No replies
Through the display ip interface GE0/0/0 command, you can view the statistics of ping packets received on this interface.
Chi, 1 year ago
116
1
No replies
After deploying PPP Multilink, data will be evenly distributed on each member link according to the source address and destination address.
Vicente, 1 year ago
78
1
No replies
VXLAN uses Mac in TCP encapsulation to encapsulate Layer 2 packets with Layer 3 protocols.
Galen, 1 year ago
87
1
No replies
Which of the following statements about the election of the network DR is correct?
Manual, 1 year ago
81
1
No replies
If the BFD session goes down, the direct link will fail.
Rueben, 1 year ago
116
1
No replies
When configuring the DHCP Relay function on the device, the VLANIF interface of the relay connected to the client must be bound to a DHCP server group, and the bound DHCP server group must be configured with the IP address of the DHCP server to be p
Rocky, 1 year ago
97
1
No replies
In order to quickly detect network link failures, which of the following protocols can we deploy?
Chas, 1 year ago
89
1
No replies
If you want to check the files under Flash, which command should you use?
Tuan, 1 year ago
72
1
No replies
Which of the following is the scope of manual setting of VRRP priority?
Mauro, 1 year ago
63
1
No replies
According to this figure, can we judge whether R4 is on?
Zachariah, 1 year ago
78
1
No replies
According to this figure, what can we know? (Multiple choice)
Man, 1 year ago
85
1
No replies
The ipv6 enable topology standard is configured in the IS-IS protocol view. The meaning of this command is that IPv4 and IPv6 share the same topology.
Mauro, 1 year ago
67
1
No replies
As shown in the figure, OSPF is enabled on all interfaces of the router, and the cost value of the link is advertised in area 0 according to the Loogback0 of R2 as shown in the figure, then in area 1, both R2 and R3 will transmit 10.0 in the form of
Harris, 1 year ago
78
1
No replies
Page 3 / 9
Share: