Notifications
Clear all
Topic starter
Refer to the exhibit.
A port channel is configured between SW2 and SW3. SW2 is not running a Cisco operating system. When all physical connections are made, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
- A . The port-channel mode should be set to auto.
B. The port channel on SW2 is using an incompatible protocol.
C. The port-channel trunk is not allowing the native VLAN.
D. The port-channel interface load balance should be set to src-mac.
Suggested Answer: B
Posted : 23/01/2023 11:23 pm