Notifications
Clear all
Topic starter
Refer to the exhibit.
An engineer reconfigures the port-channel between SW1 and SW2 from an access port to a trunk and immediately notices this error in SW1's log:
*Mar 1 09:47:22.245: %PM-4-ERR_DISABLE: bpduguard error detected on Gi0/0, putting Gi0/0 in err-disable state
Which command set resolves this error?
- A . SW1(config-if)#interface Gi0/0
SW1(config-if)#no spanning-tree bpdufilter
SW1(config-if)#shut
SW1(config-if)#no shut
B. SW1(config-if)#interface Gi0/0
SW1(config-if)#no spanning-tree bpduguard enable
SW1(config-if)#shut
SW1(config-if)#no shut
C. SW1(config-if)#interface Gi0/0
SW1(config-if)#spanning-tree bpduguard enable
SW1(config-if)#shut
SW1(config-if)#no shut
D. SW1(config-if)#interface Gi0/1
SW1(config-if)#spanning-tree bpduguard enable
SW1(config-if)#shut
SW1(config-if)#no shut
Suggested Answer: B
Posted : 27/10/2022 4:18 am