Notifications
Clear all
Topic starter
02/10/2022 10:45 pm
After the initial installation on Check Point appliance, you notice that the Management-interface and default gateway are incorrect.
Which commands could you use to set the IP to 192.168.80.200/24 and default gateway to 192.168.80.1.
- A . set interface Mgmt ipv4-address 192.168.80.200 mask-length 24set static-route default nexthop gateway address 192.168.80.1 onsave config
- B . set interface Mgmt ipv4-address 192.168.80.200 255.255.255.0add static-route 0.0.0.0. 0.0.0.0 gw 192.168.80.1 onsave config
- C . set interface Mgmt ipv4-address 192.168.80.200 255.255.255.0set static-route 0.0.0.0. 0.0.0.0 gw 192.168.80.1 onsave config
- D . set interface Mgmt ipv4-address 192.168.80.200 mask-length 24add static-route default nexthop gateway address 192.168.80.1 onsave config
Suggested Answer: A