You need to impleme...
 
Notifications
Clear all

You need to implement an Azure load balancer for the NVAs. The solution must meet the following requirements:

1 Posts
1 Users
0 Likes
168 Views
(@pochethurman)
Noble Member
Joined: 2 years ago
Posts: 704
Topic starter  

You have an azure subscription that contain a virtual named VNet1. VNet1. contains four subnets named Gatesway, perimeter, NVA, and production.

The NVA contain two network virtual appliance (NVAs) that will network traffic inspection between the perimeter subnet and the production subnet.

You need to implement an Azure load balancer for the NVAs. The solution must meet the following requirements:

✑ The NVAs must run in an active-active configuration that uses automatic failover. ✑ The NVA must load balance traffic to two services on the Production subnet. The

services have different IP addresses

Which three actions should you perform? Each correct answer presents parts of the solution.

NOTE: Each correct selection is worth one point.

  • A . Add two load balancing rules that have HA Ports enabled and Floating IP disabled.
  • B . Deploy a standard load balancer.
  • C . Add a frontend IP configuration, two backend pools, and a health prob.
  • D . Add a frontend IP configuration, a backend pool, and a health probe.
  • E . Add two load balancing rules that have HA Ports and Floating IP enabled.
  • F . Deploy a basic load balancer.

Show Answer Hide Answer

Suggested Answer: B,C,E

Explanation:

A standard load balancer is required for the HA ports.

-Two backend pools are needed as there are two services with different IP addresses.

-Floating IP rule is used where backend ports are reused.

   
Quote

Latest Microsoft AZ-104 Dumps Valid Version

Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
Share: