Notifications
Clear all
Topic starter
Refer to the exhibit.
After an engineer configures an EtherChannel between switch SW1 and switch SW2, this error message is logged on switch SW2:
Based on the output from switch SW1 and the log message received on switch SW2, what action should the engineer take to resolve this issue?
- A . Configure the same protocol on the EtherChannel on switch SW1 and SW2.
B. Define the correct port members on the EtherChannel on switch SW1.
C. Correct the configuration error on Interface Gi0/0 on switch SW1.
D. Correct the configuration error on Interface Gi0/1 on switch SW1.
Suggested Answer: A
Posted : 24/11/2022 11:04 pm