300-610

An engineer is designing a Multichassis EtherChannel topology in which two switches must appear as a single device to a third downstream switch? Which two technologies meet this requirement? (Choose two.)

First post and replies  | Last post by Jacques, 3 months ago

Which multicast rendezvous point redundancy mode is valid for Bidirectional PIM?

First post and replies  | Last post by Morgan, 3 months ago

Which mode must be enabled on a Cisco UCS Fabric Interconnect to connect directly to a storage array?

First post and replies  | Last post by Zachariah, 3 months ago

Which authentication software natively runs within the CLI of Cisco NX-OS devices?

First post and replies  | Last post by Randolph, 3 months ago

Drag and drop the data center technologies from the left onto the correct descriptions on the right. Not all technologies are used

First post and replies  | Last post by Vicente, 3 months ago

A Cisco UCS instance has four interfaces on a UCS VIC. Where on the fabric interconnect does each interface terminate?

First post and replies  | Last post by Galen, 3 months ago

How is out-of-band management access provided for each VDC?

First post and replies  | Last post by Rocky, 3 months ago

Which two configurations allow for routing traffic between two VDCs? (Choose two.)

First post and replies  | Last post by Colton, 3 months ago

Which two configuration methods can be used to deploy QoS to Cisco MDS Series switches? (Choose two.)

First post and replies  | Last post by Colton, 3 months ago

Drag and drop the SAN components from the left onto the correct design considerations on the right

First post and replies  | Last post by Harris, 3 months ago

Which two automation requirements can be met by using Puppet? (Choose two.)

First post and replies  | Last post by Zachariah, 3 months ago

When planning to deploy a load-balancing service as a managed node, which ACI configuration must be included?

First post and replies  | Last post by Ali, 4 months ago

Which two naming formats identify target or initiator iSCSI nodes? (Choose two.)

First post and replies  | Last post by Carrol, 4 months ago

Drag and drop the technologies from the left onto the correct descriptions on the right

First post and replies  | Last post by Rayford, 4 months ago

A failure occurs on the network between two BFD and OSPF neighbors. Drag and drop the protocol actions from the left into the correct order on the right

First post and replies  | Last post by Philip, 4 months ago

Drag and drop the components from the left onto the descriptions on the right that indicate what occurs to Fibre Channel fabric when that component fails

First post and replies  | Last post by Gonzalo, 4 months ago

What is a design consideration when implementing FSPF?

First post and replies  | Last post by Mario, 4 months ago

Which type of encoding is used on 8-Gbps links as compared to 10-Gbps links?

First post and replies  | Last post by Jacques, 4 months ago

What is the result of this policy?

First post and replies  | Last post by Harris, 4 months ago

Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right

First post and replies  | Last post by Orval, 4 months ago

What must be the default gateway of the servers in EPG Web?

First post and replies  | Last post by Ernest, 4 months ago

Which orchestration tool should be used for the management and analytics of servers across multiple sites?

First post and replies  | Last post by Jacques, 5 months ago

Which feature must be configured to connect a classical Ethernet network to a data center network so that the data center network appears to be one large switch.

First post and replies  | Last post by Mikel, 5 months ago

Drag and drop the Cisco Nexus 7000 Series Switch resources from the left onto the correct groups on the right

First post and replies  | Last post by Man, 5 months ago

Which factor determines the choice of platform designing a Cisco HyperFlex infrastructure to support computer-aided design applications?

First post and replies  | Last post by Gonzalo, 5 months ago

Which protocol prevents fiber failures from causing a Layer 2 loop in a dark fiber DCI?

First post and replies  | Last post by Eldridge, 5 months ago

Which two statements describe Ethernet switching mode on Cisco UCS 6100 Series Fabric Interconnects? (Choose two.)

First post and replies  | Last post by Gonzalo, 5 months ago

Which type fields can an engineer use to identify an iSCSI participant? (Choose two.)

First post and replies  | Last post by Tuan, 5 months ago

Which technology enables Layer 2 extension between remote data center sites?

First post and replies  | Last post by Harris, 5 months ago

Which two vSphere features must be included in the design of a Cisco HyperFlex systems stretched cluster? (Choose two.)

First post and replies  | Last post by Rashad, 5 months ago