Notifications
Clear all
Topic starter
09/07/2022 9:45 pm
Refer to the exhibit.
Based on the LACP neighbor status, in which mode is the SW1 port channel configured?
- A . passive
- B . mode on
- C . auto
- D . active
Suggested Answer: D
Explanation:
From the neighbor status, we notice the “Flags” are SP. “P” here means the neighbor is in Passive mode.
In order to create an Etherchannel interface, the (local) SW1 ports should be in Active mode.
Moreover, the “Port State” in the exhibit is “0x3c” (which equals to “00111100 in binary format).
Bit 3 is “1” which means the ports are synchronizing -> the ports are working so the local ports should be in Active mode.
Explanation:
From the neighbor status, we notice the “Flags” are SP. “P” here means the neighbor is in Passive mode.
In order to create an Etherchannel interface, the (local) SW1 ports should be in Active mode.
Moreover, the “Port State” in the exhibit is “0x3c” (which equals to “00111100 in binary format).
Bit 3 is “1” which means the ports are synchronizing -> the ports are working so the local ports should be in Active mode.